Recent content by Papa John

1) Kirban Valve Spring Tool Removal Kit(comes with shaft already predrilled) - $15 +S & H 2) Brand New Coil Pack From Kirban, I broke the little tabs though - It's about $60 from there, if you know how to fix it Make me an offer. 3) Stock Bad Coil Pack from my '87 GN - make offer 4)...

Hey, one of my cars should be a '95 TSi, but all the parts are coming out to match a '97 model!! Can somebody please run a carfax? VIN: 4E3AL54FXSE057263

103K original miles, no t-tops, almost perfect interior, decent paint with straight body. power everything(all works). runs/shifts great. Clean title. I bought the car with 96K. At around 97k, I parked the car for two months and replaced a lot of things under the hood. Not because I had to, I...

I know O'reily's has 'em.

hey guys, I have a Kirban's adj. fuel pressure regulator and I remember reading somewhere that the instructions that came with it are wrong. What should I set my pressure to?

TTT

hey guys, I have a Jeg's fuel pressure gauge and I was wondering what are the specs for the fitting that I need to be able to mount it on the fuel rail? Also, what should I set my fuel pressure to? I don't have any mods at the moment.

thanks guys!

Do those bolts need to be torqued to a certain spec? I tried a search and could not find anything. :confused:

and I was at the point where you "get to" allign the pushrod from the back of the master cylinder to the pin on the brake petal. However, while doing so the push rod from the MC came out. I read somewhere that it could be done that way as an easier alternative, but when I put the pushrod back...

I'm in the middle of installing my new powermaster and I guess I'm supposed to take the ball off the new unit to be able to bolt the whole unit on, right? I was making sure that was right and I was not hurting anything. Also, what is the torque spec on that ball when I put it back on? Thanks.

Which one should I get? :) I tried doing a search, and they all seem about the same and seems pretty safe to go with any of them. However, I just want to make sure there isn't one that sticks out.

On the bottom of it, there is a vac. line that goes to the wastegate, what is supposed to go on the top?

Are the ones from Autozone/O'reilley's ok to use? The Borg Wagner one from O'reilley's looks like the sensor is just fixed in a location, and there is still a bolt that goes through the middle of the bracket?

thank you very much!!:D