Recent content by rssooner

  1. R

    6262 - Any reputable advertisers running any specials?

    I don't mean to steal this thread but I am interested in upgrading my TE60 to a 6262. I have an unopened motor except valve springs, PTC 9" LU with 3000 stall, upgraded SLIC, ALKY, etc. etc. I also want to upgrade stock ECM to Eric Marshall's ECM.
  2. R

    BUICK and CADILLAC TEST N TUNE Aug 10th

    Any word on rescheduling this event?
  3. R

    Bumper Fillers

    I ordered Spool Fool. They are great. I did take them to get painted and they turned out great.
  4. R

    BUICK and CADILLAC TEST N TUNE Aug 10th

    Let's do this....
  5. R

    Lug bolts/Lug nuts causing me fits

    I love your signature...cracks me up.
  6. R

    Lug bolts/Lug nuts causing me fits

    correct taps and dies? i'm unfamiliar with what this is...
  7. R

    Lug bolts/Lug nuts causing me fits

    The couple I have had fits with fit and screw on fine until about 1/3 to 1/2 way down the bolt then it becomes VERY hard to advance...even with an impact wrench. Others have said I may have the wrong nut/bolt combo but I am using the same with all 10 and having issues with only a couple. Why I...
  8. R

    Lug bolts/Lug nuts causing me fits

    Hello everyone. I have moser axles and 3" lug bolts with open ended lug nuts. I had issues with tightening a couple of the lug nuts all the way. It was like they were cross threaded or something about 1/4 to 1/2 way down. One of the bolts broke so I had to remove the axles in order to...
  9. R

    Best 1/8th mile To date.

    very impressive. Where in TX are you located? xtreme raceway park is the new place south of Dallas? I heard good things about it.
  10. R

    Biggest turbo for stock heads?

    I don't remember...been quite a while ago..
  11. R

    Biggest turbo for stock heads?

    When I ran my 11.78 I had 28x9 slicks on weld draglite wheels. 28x10.5 didnt fit. I also had my exhaust opened. I have one of those stageright transbrakes too but probably launched with only about 5lbs. I was highly advised to put 1/2 93 unleaded and 1/2 C16 for the extra insurance and...
  12. R

    Biggest turbo for stock heads?

    Thanks for the reply... I'm just looking for low 11s. my suspension consist of HR upper/lower rear control arms and HR rear sway bar. Everything else is stock. I ran on slicks but I haven't run the car at the track in over 10 years.... So you're saying the TE60 performs much better at 25...
  13. R

    Biggest turbo for stock heads?

    What else do I need? How much boost? Thanks!
  14. R

    Biggest turbo for stock heads?

    Thanks everyone for the replies. My et goal would be low 11s. My overall plan is to do heads and use the TE60 to get there since I haven’t maxed out this turbo yet.
  15. R

    Biggest turbo for stock heads?

    Hello everyone. 87GN with all the goodies (50lb injectors, DW300 fuel pump, SLIC, ALKY, PTC 3000, TT 5.7, 3" DP and exhaust, Powerlogger etc.) I have a TE-60 that I have had in the car for a loooong time. Unfortunately, I am not that up to date with the current turbos. My question is what...
Top