So I have to splice the wires to the fuel pump to the stock connector on my T-type because I am using a different pump. Any suggestions when splicing wires in side the tank. I was thinking solder then heat shrink twice?
Here is what I am talking about:
I recentyl purchased a RX-G75-FPA pump and RX-G7-FPWHG Pump Hotwire Harness. I own a Lesabre t-type that I am doing a L67 motor swap and my stock fuel pump harness connectors are not the same as the ones on the GN hot-wire harness which I knew before hand. I wanted to know if anyone had any...
Was not sure where to put this, sorry. Didnt really see where it fit in...
Well as some of you may know I purchased another T-type because my original silver T was far to rusted to save (from a economical stand point). If curious you can see all that is going on at the lesabre site: The...
Hey guys, specifically you all in Seattle. I have a favor to ask of someone here. My 89 Lesabre T-type has proven to rusty to salvage and I am already equipped to do this project, but need to get a good car.
I am looking at this car here...
I am putting a S/C 3800 in me Lesabre T-type and need a fuel pump for it. Another guy who has done this swap said to use the walbro 307 but they don't make that anymore than I thought it was the 340? Anyway I see racetronix has a kit plus hot-wire for a decent price but they have different...
The car weighs 3300 plus my at 200lbs.
As for the tuner. What operating system does it require. We have a lab top for our GN with direct scan on it but it uses an old windows system.
I will be honest I have never tuned a car. Our GN has the direct scan, but I have not messed with it much...
murphinator
You have seen my posts on other sites about the L67 in my 89 Lesabre T-Type. I am using a single muffler set up (like an f-body) along with these mods:
Re-Programmed PCM (needs to be done anyway)
Power Log and rear ported man
Ceramic Coated Cross-Over Pipe
Down Pipe (3in with...
Some of you may have seen my silver 89 Lesabre T-type for sale here a long while back, but it didn't leave. Due to some unforeseen circumstances I kept it. I have decided to "restore" it and make it like new so I will have a very cool daily driver and for a lot cheaper than any car I would want...
I heard sometime ago that the person who ran GNXdash.com just up and quit making them for some reason or another. I know poston makes them but with out the clear plastic and the mounting plate looks ok but a little cheap with the texture, but that is just my opinion. Southeast turbo had what...