Recent content by yipekiya

  1. Y

    S2 Clear Out Selling all of my stuff Dale Jarrets old engine

    Sold
  2. Y

    S2 Clear Out Selling all of my stuff Dale Jarrets old engine

    Update the bore is 4:020 unfinished and the rods are Carillo's sorry
  3. Y

    S2 Clear Out Selling all of my stuff Dale Jarrets old engine

    OK I have been holding on to this stuff for like 3 or 4 years now and I am not going to use it in the forseable future so I am selling it all offered here first... I bought what was left of two Dale Jarret engines here are the details. Block On center Stage two 4.010 bore I will double chack...
  4. Y

    needed program PLEASE HELP!

    Please email it to me yipekiya@shaw.ca Thanks Rob
  5. Y

    needed program PLEASE HELP!

    Need a chip for following combo...Please email me program if you have a suitable match 109 block 218 218 cam chamion GN1;s 72 P trim 3 inch pipe 55'S We will be running C16 Mid - HIgh 20lbs boost. Any help would be appreciated. Regards Rob
  6. Y

    B&M tranny controller wiring...

    I have a tr equipped with a FAST system here, just trying to install the B&M lockup controller. I ordered the one setup for an electronic speedo without giving it much though. When I went to look at the wiring diagram tonight I ran into a few questions. The controller is looking for a...
  7. Y

    Input shaft end play spec?

    Just a quick question for the gurus. I'm doing the final assembly of my 2004r, checking the input shaft end play. Right now I have .030, the atsg manual says .005-.015. Should I worry? Are the selectives still available from the General? My printout only lists the Violet washer I'll...
  8. Y

    Need Help FAST>>>>>1007 Gasket Instructions

    I would really like to put my heads on tonight.....No FN instructions for the gaskets....Fel Pro 1007 receiver grooves.....Help Me Please.... Rob
  9. Y

    Powermaster VS Vacum

    Ok,, Purchased the car not running with vacum brakes already installed, I have never run the car. Now the engine and trans are ready to go and I am debating switching back to a powermaster. However I see many people ditching it... Questions---Is it harder to build boost on launch with Vacum...
  10. Y

    Selling my 2004R with PTS goodies, Converter, Alto Clutches Etc..

    I put very serious consideration into the 200 however it comes down to the money. A 200 needs some serious parts to handle 1000+ HP. The 400 is a cheaper alternative.
  11. Y

    Selling my 2004R with PTS goodies, Converter, Alto Clutches Etc..

    Trans and All Parts on Ebay Package Deal. All Parts are brand new http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=1871990156 Reason for Sale-- Going to run a 400 with Brake
  12. Y

    Main Bearing clearance

    I am looking for opinions on Main clearances: Clevite H bearing--Street Strip Application. Thanks Rob
  13. Y

    Needed Top Plates for Rev Kit

    In the process of final assembly of my engine,,,,missing the top plates for the Rev Kit...Stage2 Heads.. Can anyone help me???would like them asap Regards Rob
  14. Y

    Stage II

    You can sell your block. I will sell you a never run complete Stage motor ready to go.....Save $$$ and about a year or two...lol Rob
  15. Y

    Main Caps VS Block Girdle

    RJC Girdle vs: main caps any experince I am waying out the pro's & Con,s of each.. Any opinions appreciated. Regards Rob
See more
Top