3.8 engine block

[oxl832]

looking for a 3.8 engine block rear wheel drive

 

[81Regal]

Where are you at?

 

[oxl832]

Where are you at?

I am located in Bellingham, wash

 

[turbopower87gn]

I have a .030 over with stk crank needs turned and trw pistons stk rods will need 1 piston was magaflexed take 500. and shipping

 

[oxl832]

I have a .030 over with stk crank needs turned and trw pistons stk rods will need 1 piston was magaflexed take 500. and shipping

What is the casting # on the block?

 

[androboost4]

I have one .you will like the price. If you are building a low to medium HP motor this early 3.8 block will do
Fine , I Know as I have built one for myself. I have a spare block that has never been bored . Also I'm not too far from you. Let me know.

 

[turbopower87gn]

sold loc sorry

 

[oxl832]

I have one .you will like the price. If you are building a low to medium HP motor this early 3.8 block will do
Fine , I Know as I have built one for myself. I have a spare block that has never been bored . Also I'm not too far from you. Let me know.

I would need a block that would take close to 600 HP, I would prefer a 86 or 87 block. The block I have cracked around the main journal webs. Where are you located?
Thank You

 

[androboost4]

Hi , I call Lynden Home most of the time . If you going for 600 HP, personally I would recommend a TA Aluminum block if your budget will allow it. There is no question about their blocks handling 1200 HP easily .
Sorry I can't help with a 109 block.

 

[oxl832]

Hi , I call Lynden Home most of the time . If you going for 600 HP, personally I would recommend a TA Aluminum block if your budget will allow it. There is no question about their blocks handling 1200 HP easily .
Sorry I can't help with a 109 block.

Well, you are close, but I think I will hold out for the 109 block.
Thanks anyway

 

[androboost4]

Good luck on your search .