I recently purchased an 87 Turbo T and am currently going though it to see what I have and what all has been done. It has a Scanmaster installed and in verifying the wiring it has the white wire connected to the ALDL connector but also has a wire spliced to it going to the ECM. Ok to just delete the wire to the ECM?
Scanmaster 2.1 wiring question
- Thread starter Selfel
- Start date
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
Jonasterg
Active Member
- Joined
- May 25, 2001
- Messages
- 379
How quickly does your SM update? That could be the PowerLogger wire.
- Joined
- Jul 28, 2020
- Messages
- 952
What terminal on the ECU does the wire from the Scanmaster go?
- Joined
- Aug 1, 2003
- Messages
- 9,826
to the op
if you have a scanmaster 2.1 and it shows 2.1 on display when powered up ...the white goes to the aldl ( E)or the ecm at A8
no need to have the white wire connected to aldl plug and ecm ...its the same
if you have a powerlogger (and a scanmaster 2.2 chip installed in the scanmaster ) you should make use of the faster data stream from it and connect white wire to the to the aux block scm terminal
if you have a scanmaster 2.1 and it shows 2.1 on display when powered up ...the white goes to the aldl ( E)or the ecm at A8
no need to have the white wire connected to aldl plug and ecm ...its the same
if you have a powerlogger (and a scanmaster 2.2 chip installed in the scanmaster ) you should make use of the faster data stream from it and connect white wire to the to the aux block scm terminal
Last edited:
