Whats up guys..i need a little help...i bought a turbo from a board member a while ago and i am just getting to use it now...anyway upon further inspection i noticed a longer bolt to hold down the wastegate actuator...i noticed this because it was sticking up not actually holding the actuator down...anyway like i said its been a while i had this on the shelf...so i notice that the bolt pierced through the housing so of course i took it apart to make sure the piece of aluminum doesnt come off and enter the turbo and cause any damage...so my questions are....
1. Im thinking a lil thread sealer on a shorter bolt should work fine
2. Where do i get the o ring that of course broke apart...
3 any tips or tricks to the o ring..it looked like it had sealer or something keeping it on
4.should i use a copper gasket for the exh side to the dp or just copper silicone....thnx guys vinny
1. Im thinking a lil thread sealer on a shorter bolt should work fine
2. Where do i get the o ring that of course broke apart...
3 any tips or tricks to the o ring..it looked like it had sealer or something keeping it on
4.should i use a copper gasket for the exh side to the dp or just copper silicone....thnx guys vinny
