STF420@comcast.
Active Member
- Joined
- Oct 6, 2003
- Messages
- 152
I need to change some things around on the C100 (Bulkhead connector) Body side. Most pins are the same, Except for. (Need Change/Mod)
This is what engine harness needs
A7 Tach to Dash
B4 Fan Relay PWR
C6 Pwr to Fuel inj/fuel pump (I may have since was 4.3L FI)
D4 CCCI Spark Pwr PNK/BLK (EST) May be the same need to trace
F4 Pwr for powermaster (not needed)
G6 Switched pwr to fuel pump from rly (I may have since was 4.3L FI)
H4 Pwr for ECM/SOL to WG ERG & CAN PINK/BLK
H6 ECM/SOL Pwr to tranny TCC via brake switch PPL
Does this seem right?
Thanks, Mike
This is what engine harness needs
A7 Tach to Dash
B4 Fan Relay PWR
C6 Pwr to Fuel inj/fuel pump (I may have since was 4.3L FI)
D4 CCCI Spark Pwr PNK/BLK (EST) May be the same need to trace
F4 Pwr for powermaster (not needed)
G6 Switched pwr to fuel pump from rly (I may have since was 4.3L FI)
H4 Pwr for ECM/SOL to WG ERG & CAN PINK/BLK
H6 ECM/SOL Pwr to tranny TCC via brake switch PPL
Does this seem right?
Thanks, Mike
