Street / Drag Race car. Set up for a Buick V6 Turbo and a 200R4.
$10K
NO ENGINE OR TRANSMISSION. CAR MAY HAVE 2500/3000 MILES WITH THE PARTS I PUT ON IT. Just don't use it any more. Car is a blast to drive. Ultimate sleeper. Got it in 2006 . Just had to many other cars . Put your eng and trans( My new PTC goes with the car) in an your ready to go. Sure I am forgetting stuff that goes with it.
Rear End
Has a custom built sub frame so a Mustang 8.8 rear end with stock Mustang suspension will bolt in.
Reinforced housing and welded tubes
Moser axles.
C Clip eliminators,
Eaton posi, 355 gears,
Viking double adjusting shocks
Welded in rear sway bar
UPR adjustable upper control arms
Lowers are adjustable
Dennys Nitous steel driveshaft with 1350 joints.
Custom made driveshaft loop
Battery shut off
Hi flow fan
Corvette radiator
new brake an fuel lines
New fuel pump with hot wire kit
Kenne Bell booster pump
Alky Injection dual nozzle
Hurst Line Loc
Dual #3 Exhaust
3" downpipe.
B&M Rachet Shifter with line loc button
PTC Converter 9,5 NON LOCKUP IT MAY HAVE 300 MILES ON IT.
Tranny cooler
Chassis
Chrome moly roll bar, halo, and swing outs. Certified till 8.50 ET.
Cert ran out last year.
Longer wheel studs
Engine Diaper
someone is taking the parts out shortly.
pics of eng compartment with a stockish motor
Pics at the drags.
Have a ton more.
$10K
NO ENGINE OR TRANSMISSION. CAR MAY HAVE 2500/3000 MILES WITH THE PARTS I PUT ON IT. Just don't use it any more. Car is a blast to drive. Ultimate sleeper. Got it in 2006 . Just had to many other cars . Put your eng and trans( My new PTC goes with the car) in an your ready to go. Sure I am forgetting stuff that goes with it.
Rear End
Has a custom built sub frame so a Mustang 8.8 rear end with stock Mustang suspension will bolt in.
Reinforced housing and welded tubes
Moser axles.
C Clip eliminators,
Eaton posi, 355 gears,
Viking double adjusting shocks
Welded in rear sway bar
UPR adjustable upper control arms
Lowers are adjustable
Dennys Nitous steel driveshaft with 1350 joints.
Custom made driveshaft loop
Battery shut off
Hi flow fan
Corvette radiator
new brake an fuel lines
New fuel pump with hot wire kit
Kenne Bell booster pump
Alky Injection dual nozzle
Hurst Line Loc
Dual #3 Exhaust
3" downpipe.
B&M Rachet Shifter with line loc button
PTC Converter 9,5 NON LOCKUP IT MAY HAVE 300 MILES ON IT.
Tranny cooler
Chassis
Chrome moly roll bar, halo, and swing outs. Certified till 8.50 ET.
Cert ran out last year.
Longer wheel studs
Engine Diaper
someone is taking the parts out shortly.
pics of eng compartment with a stockish motor
Pics at the drags.
Have a ton more.
