Alrighty folks, I've installed Razor's alky kit a few weeks ago and had worked perfectly until today after getting an alignment done. I'm thinking that the device used to depress the brake pedal damaged a connection in my alky wiring under the dashboard and now the alky pump will run with they key on, engine off. When I start the engine the alky pump does not run.
I've double checked all the connections and can't find out where the issue is coming from. The fuse on the PAC is fine, tested with a volt meter. During the kit installation I used the TPS/MAP harness and the kit has worked perfectly up until now. I've just gone through and redone all the crimped connections under the dash and I'm still having this issue.
Any ideas?
I've double checked all the connections and can't find out where the issue is coming from. The fuse on the PAC is fine, tested with a volt meter. During the kit installation I used the TPS/MAP harness and the kit has worked perfectly up until now. I've just gone through and redone all the crimped connections under the dash and I'm still having this issue.
Any ideas?