at the track?

[wbzautocustomiz]

To run a car that is in tune that is street driven without alky injection, if you run race gas to run at track to see what car can do is that ok? I dont have alky on car but I want to take car out to dragstrip run it for fun. Thanks in advance TBer's

 

[forzfed]

What boost and timing are you going to run? Do you have a scan tool?

 

[wbzautocustomiz]

around 15-18 psi according to am boost gauge when I get into it driving, timing not sure the exacts of what its set at but its a tt chip burned for 42# inj for 18psi per eric at tt. Yes a scanmaster 2.0 is in car

 

[forzfed]

Your probably running street timing, you can mix 5 gals of race fuel or so. If you have 10 gal of 94 in the tank and you add 5 gal of 108 your going to have (10x94 + 5x108)/15 = 98.6 octane. Be cautious, the scan master doesn't have a very good refresh rate.

 

[wbzautocustomiz]

when you say refresh you mean when it will show KR? And I aint planning on running too hard just want to take out on a couple of test n tune days

 

[forzfed]

when you say refresh you mean when it will show KR?

Yes, that is exactly what I mean. You should be fine with some race fuel in it.

 

[wbzautocustomiz]

thanks test and tune I will go