cat flange

[luisturbog]

anybody have a flange for hot air catalytic converter to down pipe available?

 

[BRAD_PADGETT]

Do you mean the square one with four bolt holes welded to the end of the downpipe? Brad

 

[luisturbog]

Do you mean the square one with four bolt holes welded to the end of the downpipe? Brad

the opposite side of that one; on the cat.

 

[BRAD_PADGETT]

I do not have that one. Brad

 

[luisturbog]

the opposite side of that one; on the cat.

Hey brad, what I meant was that same side; just the side that would bolt to it.
Not the side that goes to exhaust!

 

[novaderrik]

make one.

 

[luisturbog]

make one.

I don't have that type of equipmet! But i did think of going to wrecking yard to see if i could find one. I have a test pipe i just got and want to get it welded on. bolt on bolt off.

 

[luisturbog]

I don't have that type of equipmet! But i did think of going to wrecking yard to see if i could find one. I have a test pipe i just got and want to get it welded on. bolt on bolt off.

I remember atr used to sell this; and even the test pipe with it already welded on! I can't believe no one took over that biz.

 

[b4black]

NAPA carries them. You may need to look at a picture in thier parts book to make sure it's the right one.

 

[Instro84]

i got a hooker test pipe with on it if that helps.

 

[novaderrik]

I don't have that type of equipmet!

you don't have a grinder, drill, a 3/8" drill bit, and a 2.5" hole saw?

 

[Rottydogg84GN]

Just go to an exhaust place and see if they would makyou one since you have some of the parts already

 

[luisturbog]

you don't have a grinder, drill, a 3/8" drill bit, and a 2.5" hole saw?

I have a drill and 3/8 drill bit. no grinder, no holesaw!

 

[luisturbog]

i got a hooker test pipe with on it if that helps.

what are you asking for test pipe?

 

[Rottydogg84GN]

Tell then that you think your cat is bad and you would like a test pipe. Tell them that it needs the ball end to hook up to your exhaust.

 

[tb3]

never mind, I reread your post and realised I was giving useless info.

 

[TURBO E38]

Walker 31519 Flange, Walker 31914 gasket

anybody have a flange for hot air catalytic converter to down pipe available?

AVAILABLE AT NAPA SAME PART NUMBERS 31519 weld flange
31914 exhaust gasket for above

REGARDS<> TURBO E38