- Joined
- May 26, 2001
- Messages
- 9,208
This set of GN-1 heads has been completely redone with new valves and guides.
The valves are 2" on the intake, and 1.60" exhaust and have been mocked up on a 109 block to confirm proper fit.
The port work that was previously done went into the low 9's in a GN with a 109 block.
The owner no longer is racing, and is selling these heads for a fraction of what it would cost to duplicate at $1550.
Since I have not figured out how to post pictures in this new format, I can send them to anyone that will e-mail me direct, PM's will not work either.
The valves are 2" on the intake, and 1.60" exhaust and have been mocked up on a 109 block to confirm proper fit.
The port work that was previously done went into the low 9's in a GN with a 109 block.
The owner no longer is racing, and is selling these heads for a fraction of what it would cost to duplicate at $1550.
Since I have not figured out how to post pictures in this new format, I can send them to anyone that will e-mail me direct, PM's will not work either.
