Champion Fuel Rail fittings

[jmendlik]

Can someone tell me the fitting sizes (thread pitch) for the champion fuel rails--not the rear fittings with cross over line but the front two as shown --the one on pass side and the driver side front fittings.

I want to buy them in black anodized color not the blue ones as pictured

JM

 

[pacecarta]

the rails are drilled and tapped for 8an straight oring ,
the feed is -8an male x -8 straight oring
the fitting for the rail for hooking up a gauge is a -8 straight oring x -6an , if i were going to replace i would try to get in -4an outlet so std gauge lines and senders can be connected but that might not be possible coming from a -8
you could get a -6 female to -4 male adapter and screwit on to allow gauge hookup

 

[turbogn_231]

Please let me know if you end up doing this. I just had Racetronix make me a feed hose for the back side using the coated teflon line and black Fragola fittings(like the rest of my fuel system) but I haven't looked for the front fittings yet.

 

[jmendlik]

Ordered from Jegs today



027-15607

Aeromotive 15607 - Aeromotive ''AN'' Fittings and O-Rings

ORB/AN Flare Adapter

• -8AN to -8AN

$16.99$16.99
1027-15605

Aeromotive 15605 - Aeromotive ''AN'' Fittings and

 

[turbogn_231]

Thank you.

 

[pacecarta]

dont forget to order a -6an cap ( like the one you have in blue) if you arent using the -6 port

 

[turbogn_231]

The only other thing that I need to do is to hook up a Fuel logging kit that I bought from Caspers. Do you guys have any idea what size the transducer is and how I would attach it to this setup?

 

[pacecarta]

transducer is 1/8" mnpt (male npt)

 

[pacecarta]

havent tried this but this is one way as long as you use the cap on it

http://www.summitracing.com/parts/rus-670343/overview/
edit found even cheaper
http://www.summitracing.com/parts/fra-495005-bl/overview/

 

[turbogn_231]

Thanks. I'll use this w/ a cap.
-6 AN Male to -6 AN Female, 1/8 in. NPT Gauge Port

 

[Nero328]

This is awesome! I was wondering the exact same thing and now I was able to order what I needed before getting my intake! How about the back fittings? I want to replace those with black too...any idea what size they are? They look like 8 but I can't tell

 

[pacecarta]

both ends of rail are drilled for same -08 orb into rail , the rear fittings were angled -08AN male fittings , some early champ rails were 90deg.. newer are 45deg

 

[Nero328]

both ends of rail are drilled for same -08 orb into rail , the rear fittings were angled -08AN male fittings , some early champ rails were 90deg.. newer are 45deg

Thanks!!