I was driving around the other day, and everything was fine. I went to the entrance ramp to the freeway and applied the gas slowly. Then the car just died (no pop no surge). I coasted over and tried to restart the car. It would crank, but not fire. I got the vehicle towed home.
I run the TurboTweak Speed Density (SD) chip (no MAF). The car runs off the MAP sensor. At home, I did a continuity test on all the MAP wires to their destination. I wiggled the wires and still had continuity.
Fuel pressure is good (40@KO)
All fuses checked ok.
I replaced the crank sensor. No start
I replaced the coil pack. No start.
Plug Wires are ok (via ohm check)
New battery
Please see attached Powerlogger file of crank/no start. Looking for advice.
I run the TurboTweak Speed Density (SD) chip (no MAF). The car runs off the MAP sensor. At home, I did a continuity test on all the MAP wires to their destination. I wiggled the wires and still had continuity.
Fuel pressure is good (40@KO)
All fuses checked ok.
I replaced the crank sensor. No start
I replaced the coil pack. No start.
Plug Wires are ok (via ohm check)
New battery
Please see attached Powerlogger file of crank/no start. Looking for advice.