daul feeding ???

[11.20n1320]

I need to know what holes to drill in the plate when daul feeding.I removed the center sealing ring on the center support and the inner seal on the direct drum. I have a stock unmoddified X plate.I would have used CKs plate but need this done tomorrow.

 

[mikestertwo]

You don't have to drill any holes in the plate. You do have to plug the reverse feed hole in the bolt that holds the center support.

 

[Sal Lubrano]

May I ask a question. If the reverse feed hole is pluged. Then how is reverse applied?

 

[mikestertwo]

May I ask a question. If the reverse feed hole is pluged. Then how is reverse applied?

Through the direct clutch feed.

 

[Sal Lubrano]

Thank you. I did not realize when in reverse both area's (inner and outer) of the piston are applied. Strange how GM fed reverse with both area's of the piston but in third only fed the inner piston. Thanks for the help.