Did I do this correctly ? Powerlogger file inside.

[yullose]

My first time saving and uploading a PL file... Just seeing if it works.

 

[Rubicon 327]

Not working for me, but then I'm no puter wiz either.:redface:

 

[yullose]

I may not be saving the files correctly...

I tried to download and read it and can't get it to work for me either. lol

Ah hah.. I think what you need to do is... right click on the link and save the zip file to your computer. Once it's downloaded, click on the zip file to open it and retrieve the .dat file. Start the powerlogger console, click "load" and select the file you just pulled from the zip folder. Click on the gage console or data console... then hit your right or left arrows to move thru the saved data.

 

[pacecarta]

looks like an idle log with athrottle blip

also looks like a std chip set on defaults as the blm grid is 128 except for first cell

tps looks good .44
iac looks good
temps normal
maf looks high (6.6gm/sec )check translator settings ..
blm cell #1 dropping to 123 (pulling fuel) could be a sign of a slightly high FP

 

[pacecarta]

i see you have the wb and egt working just fine
is v4 input the fuel pressure ??

 

[yullose]

i see you have the wb and egt working just fine
is v4 input the fuel pressure ??

Yep, 4 is the fuel pressure... I have a nice Snap-on gage I plan to use to set the pressure... then match the Powerlogger to that... so I'm always seeing accurate F/P readings. The Autometer gage in the dash is just for decoration. I don't use it to set F/P.

This is the gage I always use to set F/P.

 

[yullose]

I checked my fuel pressure and it was 42.5psi. I bumped it up to 43 on the money and unplugged/reset the ECM.

I also checked my Powerlogger F/P numbers against my Snap On gage... and the Powerlogger is reading 3psi low. At idle, vac line off.. PL is telling me 40psi...(via Autometer transducer) when my good gage says 43psi.
Any idea how to adjust that ? I tried playing with the A4 adjustment volts, but it made zero difference.

Here's another brief file... idling a bit, a blip of the throttle... more idling, then pulled into gear... back to park... back into gear... then park again.

 

[wickedtt]

I may not be saving the files correctly...

I tried to download and read it and can't get it to work for me either. lol

Ah hah.. I think what you need to do is... right click on the link and save the zip file to your computer. Once it's downloaded, click on the zip file to open it and retrieve the .dat file. Start the powerlogger console, click "load" and select the file you just pulled from the zip folder. Click on the gage console or data console... then hit your right or left arrows to move thru the saved data.

so you could only read these files if you have the powerlogger software installed on your computer?

 

[yullose]

so you could only read these files if you have the powerlogger software installed on your computer?

That is correct.

It's a quick and simple download... no need to be plugged into the car.

I downloaded it to my desktop PC to play with.

You can download it HERE.