Digital Dash 3 bar MAP wiring

[Hammer231]

I've got Razor's kit about 80% installed. Just a few questions about the MAP wiring on the digital dash cars. I have to run a wire from the top wire of TPS sensor to the grey wire going to terminal C of the MAP sensor for a 5 volt source? I then run the black wire (terminal A) to ground? Is this correct? I'm no stranger to turning wrenches but this wiring stuff is new to me Can't wait to get this puppy rolling. Any hints or install pics are appreciated.

 

[Razor]

Thats correct...

Clean out the plug before inserting it into the MAP sensor. As crud may be lodged inside it. WD 40 works great for this. And careful on your connections .. make sure theyre tight. Get your ground from the bolt by the battery on the inner fender. Make sure its connections are tight.

If you want to test the 3 bar, use a digital voltmeter and measure the green wire when you turn IGN on. It will read 1.6vdc.