Digital Dash

[geetee]

I'm putting a digital dash back in my gn is there anything special that I have to do, to hook it up. Do you just push the speedo cable into the dash? The person who took it out is unavailable.

 

[GNONYX]

If I can remember when I remove mine, I lay the dash across the steering column close to the opening and attach the ground wire, and then screw the Vehicle Speed Sensor (VSS). Partially place the dash into the opening and squeeze you hand inside to connect the harness cable and then the speed cable.
If you look the PDF file on page #5 you will see the back of the digital dash where the VSS needs to connected by the speed cable is also connect to. The ground cable is screw on the lower right of the dash. To make life easier, turn ignition on before tighten to make sure all is working properly

 

[geetee]

Does the speedo cable snap in or anything, because mine did not. That clip in the back of the digital dash was I suppose to do anything with that.

 

[GNONYX]

Does the speedo cable snap in or anything, because mine did not. That clip in the back of the digital dash was I suppose to do anything with that.

in place.
Yes there is a snap clip for the speed cable housing
You just push the cable in until it snaps in; you might not hear the cable snapping in place, but you can give a little tug on the cable to make sure it.