EGR Female 4 Pin Connector?

[salvageV6]

Anybody have a part number or replacement part for a FEMALE EGR connector like would be in the EGR solenoid box?

Looking for a 4 pin EGR female connector of some type to put as an inline splice to get some signals off for my PWM solenoid pulser for my car with no EGR in the chip.

Would be easier with that female connector.

Or if anyone has a dead EGR box with good connector on it for cheep let me know.

I didn't see one at Caspers but obviously John would be making the male end for a replacement part anyway.

Already got the male end I need from a racecar with wires.

 

[gofstbuick]

I have some extra solderless weatherpak connectors, if that is what you're looking for. Do you need the round weather pak seal that go around the wire?

 

[salvageV6]

If you have the female EGR 4 pin connector that mates with the factory harness plug that would be nice.

And pins too.

Don't need any rubber seals for wire really.

A number will do also I can search and find them if you don't have one to sell.

Square pinned connector FEMALE like the EGR electronics has inside the box.

 

[gofstbuick]

The actual connector should still be available from GM or possibly NAPA

 

[salvageV6]

I tried NAPA first but was in a hurry and looked through their book kinda quick, they had the round typical weatherpak connectors but no square EGR types.

I'll email John Spina and see what he's got.

Since I'm only using power and ground from the factory plug out of the 4 pins, maybe I can just get some terminal pins that fit well into it and insulate them with shrink tube and toss a piece of 33+ tape on them to hold it in place for the test.

Only has to be in the car for emissions. Hope to see some good NOX results with it in Feb. for the test.

 

[gofstbuick]

Salvage,
If you need some weather pak connectors let me know. PM or email