just traded a car for a GN yeaterday and got a few boxes of duplicate parts. Looking to sell to get some money back on the whole deal.
Factory intercooler. Need paint to be very nice but most do. $40ea
Turbo shield cut for 3"downpipe and has a crack on the back corner- $30
2 BRF transmissions. Never saw them run-$300ea
New ford 9" center section with 4.88 gear. This was pulled for a strange section-$250
Accesory bracket with power steering pump and hose-$110
Intercooler brackets-$50 for the pair
Intake with throttle body and plenum. Looks like someone ported the intake and cleaned it up as well as the plenum. Pending sale
Fuel rail (paint looks like s---)-$30
Fuel rail with injectors and harness-$50 (found 2 more)
J bracket for turbo-$25
Factory valve covers. Dirty-$50
2 factory timing chain covers-$50ea
Front factory shrouds used to direct air into radiator (2 sides and bottom in a set) no rips just removed for front mounts-$20a set
Metal coolent lines that mount to motor-$20ea
1 set of factory heads, looks like a "backwoods" port job but are complete. Pulled off motor to put champions on.-$150
1 set of bare heads that were disassembled and hot tanked. Some light surface rust-$75
There is more and more of odds and ends so if looking for smal stock stuff just ask.
Located in davenport, ia
Factory intercooler. Need paint to be very nice but most do. $40ea
Turbo shield cut for 3"downpipe and has a crack on the back corner- $30
2 BRF transmissions. Never saw them run-$300ea
New ford 9" center section with 4.88 gear. This was pulled for a strange section-$250
Accesory bracket with power steering pump and hose-$110
Intercooler brackets-$50 for the pair
Intake with throttle body and plenum. Looks like someone ported the intake and cleaned it up as well as the plenum. Pending sale
Fuel rail (paint looks like s---)-$30
Fuel rail with injectors and harness-$50 (found 2 more)
J bracket for turbo-$25
Factory valve covers. Dirty-$50
2 factory timing chain covers-$50ea
Front factory shrouds used to direct air into radiator (2 sides and bottom in a set) no rips just removed for front mounts-$20a set
Metal coolent lines that mount to motor-$20ea
1 set of factory heads, looks like a "backwoods" port job but are complete. Pulled off motor to put champions on.-$150
1 set of bare heads that were disassembled and hot tanked. Some light surface rust-$75
There is more and more of odds and ends so if looking for smal stock stuff just ask.
Located in davenport, ia
Attachments
Last edited:
