? for Chris or anyone who might know

[Lee Thompson]

Is Chris new seperator plate already set up for dual feed? Anything I need to know about this plate before I install it. It DID NOT come with any instructions and it is not where I can look @ it right now. It will be installed in a trans that we are going to dual feed. Thanks

 

[chris718]

yes it is just omit 2 checkballs.if you didnt get instr. i can fax them.2 balls are the 3rd acc and 3rd feed

 

[Lee Thompson]

thanks

Thanks you. I believe the owner of trans has some pics that you faxed to him. As I said it is not here right now. I jsut wanted to know if the 3rd feed hole was already drilled as it may be different from your manual since the plate is a new design. Is the 3rd. feed .110 ? Thanks for your time.

 

[chris718]

lee no drilling necessary

 

[Lee Thompson]

sorry but

I have another ? then I will go away. The .060 hole that Chris recommends drilling in the direct drum---does this have any effect on dual feed. In other words will the trans work the same with or without drilling the .060 hole. Chris --I called today but you were out--hate to bother you @ work.---Thanks