Gbodyparts triple gauge pod

[highboostgn]

Has anyone had any issues fitting these in their cars? The screw holes don't even lone up where the old ones were. Are you supppose to drill nrw holes?

 

[CS99]

YES, Drill new holes. I also had to trim a little off at the very top where the pillar meets the roof

 

[mtbraun]

Drill holes or use self tapping. My fit was good but don't like that the outside edge doesn't have the curled edge like the factory original.

 

[CS99]

Drill holes or use self tapping. My fit was good but don't like that the outside edge doesn't have the curled edge like the factory original.

Get some black foam that is sticky on one surface. Wedge it in the area between the plastic and the pillar. Looks almost factory by filling in the gap with the foam.

 

[highboostgn]

Drill holes or use self tapping. My fit was good but don't like that the outside edge doesn't have the curled edge like the factory original.

Yea I didn't like that either. Other than that I'm happy with it. Good product I was thinking of heating it up and making it curve but I might try the black foam first.