HB feed line mod..

[Chuck Leeper]

Rather than plumb the p/s feed to the hb w/ all braided line, I used the original hard line out of the pump.
I used a tube bender to turn the lower end from towards the p/s gear box, to 90* off of the block.
The line is ss, so it takes a stout bender to get it done.
Once done, you can use a 16mm o'ring to -6 adapter, and hook the line from there to the hb.
Here's some pics of what it now looks like.
DAMN! I'm pretty cool!

 

[Brandon#]

Thanks for the picture, you made me realize I installed my o rings incorrectly on my HB lines.

Post up another pic once its installed, its hard to imagine that line you going from the pump to the HB.

 

[TexasT]

Nice work!

Sent from my HTC PH39100 using Tapatalk

 

[TurboBuRick]

Nice!

 

[Chuck Leeper]

Post up another pic once its installed, its hard to imagine that line you going from the pump to the HB.

I'll post a pic of it on the engine. The line coming off is just the hi psi line that goes to the HB in port..Will be a bit, B4 I can post that.
The line from this hard line will be Fragola PTFE -6.