High Flow Crossover Pipe

[Spooling]

High Flow Crossover Pipe (Action Fabrication)

Was tig welded in corner as external gate was installed on this crossover – Painted with 1850*F Cast Iron Gray Header Paint - It is VERY Nice ($50.00 shipped anywhere in the Continental USA) - SOLD

 

[TurboTJT]

Not sure what you mean by tig welded in corner for external gate.
Will this work for an internal gate setup?

 

[Spooling]

If you look at the pic - namely in the lower RH Corner of the crossover pipe - you will see that there was a small plate welded to this pipe to cover the hole where there "used to be" an external wastegate mounted - which is not mounted there anylonger.

My extarnal wastegate was moved to directly under the turbocharger - which bleeds air from all 6 cylinders - rather than only 3 where it was mounted on the crossover pipe.

Yes - this crossover pipe was used with the stock headers - which had an internal wastegate design.

Ed

 

[TurboTJT]

OK I'll take it, pm your pay info.
I assume its made of mild steel, not stainless?

 

[Spooling]

I don't remember if it was ss or not. It is possible it is stainless - it was many years ago though.

Either way - it's certainly a nice crossover pipe.

Sending PM.

Tks.

 

[TurboTJT]

I don't remember if it was ss or not. It is possible it is stainless - it was many years ago though.
Either way - it's certainly a nice crossover pipe.

That it is, its a beauty !
Paypal sent..........