hot air car cooling system upgrade

[HotAir6 v.2.0]

I'm about to upgrade the cooling system in my 84 by getting the Alradco radiator and dual electric fan setup. I see Caspers has a wiring harness so I plan to pick that up so my 86/87 ECM can talk to the fan. From what I can tell I also need a radiator hold down bracket and possibly some rubber bushings.

Where can I get the hold down bracket and the bushings?

Are there any parts I'm missing?

Any help would be greatly appreciated.

 

[NorCalTurbos]

I think gbodyparts has the rad hold down plate not sure

 

[novaderrik]

my car stays right at the 180 fan cut in temp with a Cutlass 3 core radiator held in place with the Cutlass top plate and a 16" Hayden electric fan that i found in the junkyard that is switched on and off by the ecm via a cheap Hayden relay kit..

 

[HotAir6 v.2.0]

Thanks for the input. Junkyards in my area are weak so that's not really an option. And gbodyparts only has the expensive stainless version right now which I don't think is worth it since I'm just going to paint it black, so I'll have to keep shopping for now.

 

[DCG]

Doing the same thing. I went with the modine 951 f body radiator. I just moved my lower mounts over one slot and reused them. Some one on here could probaly sell you the top plate. I went with the dodge intrepid fan. I had to sand at least a 1/8 inch of each side to make it fit between the tanks. Check ebay if you have no junkyards close. I think thats the fan your supposed to use with caspers harness upgrade. I havent made it that far yet. Still trying to figure out how i want to mount the fan.

Posted from the TurboBuick.Com mobile app

 

[Robert1mcssgn]

Cooling sys upgrade... intrepid dual fan assy with the Casper's Harness, I used these plastic clips for the tranny cooler and the radiator and hold amd look very good... hope this helps u guys... H/A build I got going on...