Chris McDade
Active Member
- Joined
- Jul 13, 2001
- Messages
- 1,840
Well the reason Im replacing head gaskets right is because my knock gage stop working the last time I was at the track.
I have the block box knock gage. With the read light and it beeps when you get any knock. When I turn the key on it beeps and works. It has a test button on it and it works. I press the botton and it beeps like its suppose to. ( So im thinking that this thing is working ). Well I get a hammer and go and hit the block and it does not beep at all. So I replaced the knock gage with a different one I had and it's doing the same thing.
I've already check the wires going into ECM and they all are connected.
Do you think that it's the sensor on the back of the block or a bad ground some where????
Any other sugustions.
Thanks an advance
I have the block box knock gage. With the read light and it beeps when you get any knock. When I turn the key on it beeps and works. It has a test button on it and it works. I press the botton and it beeps like its suppose to. ( So im thinking that this thing is working ). Well I get a hammer and go and hit the block and it does not beep at all. So I replaced the knock gage with a different one I had and it's doing the same thing.
I've already check the wires going into ECM and they all are connected.
Do you think that it's the sensor on the back of the block or a bad ground some where????
Any other sugustions.
Thanks an advance