Wanted to drop a long time needed note about my project which can be seen in the signature below. In April of 03 I brought my car to Richie Kibler in Garner, NC (TURBOKID) on this board, for some oil burning issue which at the time I thought it was valve stem seals.. Well once Richie pulled the valve covers off there was more problems then needed. Thus began the venture of redoing the ride. During the time the engine was pulled and car was being stripped Richie gave me allot of info as I am a novice to the TR's. He always found time to answer my questions regardless how stupid they would be. Needless to say that Richie has set some records out there with his monster.. (I think very close to breaking the 7'99 1320 run.)
After he pulled the motor I told him that I wanted to run in the high 10's low 11's. So in his own red kneck
way he guided me to that point with a combo that I am sure is more than adequate. Richie entertained my questions about the lower end, top end of the block, what everything does and how to get the best performance out of the 109. I have been around other places where you would get a stupid look and a bill for services rendered but Richie and his Ford compadre we as intrested in accomplishing the goal as I was. The only unfortunate thing I have experienced is that $$$$ and time was always screwed up. That is why it has taken almost a year to complete.
I am sure 150% worth that the quality and effort he put in my car is what will be reflected when my car gets cranked up for the 1st time in a while..
So, the combo is all in the signature and the current status is that I am picking it up from the painter Fri 2/13, putting the interior back in overthe weekend and taking it to Richie for final assembly and tune. And alla and the winds willing 100% complete by 3/1.
So should you need any slicks, C-xx fuel, mechanix in any fashion for any car especially the TR's Richie is the man to see. Or for the ford fans his compadre Dave (Biscuit head). You will not be dissapointed.
Check em out @ http://www.qualityautoservice.net/
After he pulled the motor I told him that I wanted to run in the high 10's low 11's. So in his own red kneck
way he guided me to that point with a combo that I am sure is more than adequate. Richie entertained my questions about the lower end, top end of the block, what everything does and how to get the best performance out of the 109. I have been around other places where you would get a stupid look and a bill for services rendered but Richie and his Ford compadre we as intrested in accomplishing the goal as I was. The only unfortunate thing I have experienced is that $$$$ and time was always screwed up. That is why it has taken almost a year to complete. I am sure 150% worth that the quality and effort he put in my car is what will be reflected when my car gets cranked up for the 1st time in a while..
So, the combo is all in the signature and the current status is that I am picking it up from the painter Fri 2/13, putting the interior back in overthe weekend and taking it to Richie for final assembly and tune. And alla and the winds willing 100% complete by 3/1.
So should you need any slicks, C-xx fuel, mechanix in any fashion for any car especially the TR's Richie is the man to see. Or for the ford fans his compadre Dave (Biscuit head). You will not be dissapointed.
Check em out @ http://www.qualityautoservice.net/
