Locking up Torque convertor with DFI gen 6.32

[Markolc]

Hi Guys. I am going to dyno my LT1 that is controlled by DFI 6.32 and the LT1 uses a 700-R4 tranny. I have the DFI controlling the Lockup points on the Convertor, but I'm new at this and I need to know if it's possible to lockup the TC at WOT in 3rd gear. I want the dyno graph to reflect my true RWHP numbers without loss from the convertor. Do I have to wire it up a certain way or can I just input value via the laptop...and if I can, what values should they be?

 

[THE CROW]

I beleieve you can't do it in 3rd gear using the DFI. I would think it would have to be manually done like grounding the TCC solenoid with a switch or through the diagnostics link. The DFI uses the 4th gear signal as one of the parameters required for lockup.

 

[Markolc]

Is there a schematic so I can wire in the switch and lock it up myself?