Logging alky and fuel with xfi + sensor?

[434nova]

When trying to log alky and fuel pressure with the caspers harness for the egr is a 12v or 5v sensor needed?
Also how would I go about setting up the sensor to read on my laptop. Do I need to input any values of the sensor?

I know I have to go into the extension adapter harness and move the pins around.

Also can I have my edash read alky instead of oil? When I rename the sensor will my edash see what it’s named?

Thank you

 

[HighPSI]

You'll need a sensor with a 12v input/5 volt output. The alky sensor needs to be higher than a 100 psi sensor. It can't be wired into the designated fuel and oil inputs (Analog 1 & Analog 2). They are not configurable other than voltage vs pressure. In other words, you can't rename them or scale then over 100psi fur the eDash. You can do everything you want on any of the other analog inputs. They just won't display on eDash

Sent from my SM-N960U1 using Tapatalk

 

[434nova]

Cal my sensor is 12v input 4.5v output. Is that gonna be a problem? It’s just a cheap eBay sensor.
Also do I need to calibrate the sensor?

Thank you

 

[HighPSI]

Should be fine. Just calibrate

Sent from my SM-N960U1 using Tapatalk