Looking For A 10.5 Pass

[BOOSTD1]

Looking To Build A 10.5 1/4 Mile Car Whats All Needed?
Here Is What I Have Now:
Stock Block
Stock Cam
Stock Intake
Adj Fuel Pres Reg
Hotwire Kit
Rjc Plate
62 Mm Tb And Plenum
Pte 6169e Turbo
65 Lb Injectors
Champion Irons
Stock Trans
Thdp And 3" Exaust
Tubed Control Arms And H&r Sway Bar
23 Row Slic
Scan Master And Kr Gauge

What Do I Need For A Cam, Roller Rockers,and Stall?
Anybody Have Any Solid 10.5 Combos?

 

[bison]

Look at my sig. You need to spend a lot more $ to have a solid 10.5 combo id lighten the car as much as possible too since you will be on the edge with the stock bottom end.

 

[affordablegn]

10 Second Combo

I also have a 10 second car!
Here is the link to my new combo.
http://www.turbobuick.com/forums/time-slip-combo-database/265758-10-29-best-pass-so-far.html
It also depends on high or low 10's???
I also ran a 10.98 with a Pte 6152 turbo on the motor.
Like Bison said, it takes a lot of dough!!!
I didn't lighten my car up but I did spend lots of dough!
Good luck on your build.
Jason
AffordableGN

 

[BOOSTD1]

picked up tonite
gn1 heads
220 comp cam roller
1.55 t&d rockers
razors alky
still looking at converters
MOTOR IS OUT .020 OVER BILLIT CAPS DIAMOND PISTONS NEW FRONT COVER
SHOULD I HAVE A GIRTLE PUT ON?
THINK THIS WILL HELP?

 

[bison]

picked up tonite
gn1 heads
220 comp cam roller
1.55 t&d rockers
razors alky
still looking at converters
MOTOR IS OUT .020 OVER BILLIT CAPS DIAMOND PISTONS NEW FRONT COVER
SHOULD I HAVE A GIRTLE PUT ON?
THINK THIS WILL HELP?

I think you should get a 9.5" PTC converter to tie it together. You will need more turbo for those heads and cam. Billet caps are fine. I wouldnt be nervous about going high 9's with that engine as long as there was zero detonation.

 

[BOOSTD1]

Looking For Injectors Size? Turbo Size?

 

[forcedfedv6]

Looking For Injectors Size? Turbo Size?

70 gtq dual or single ball bearing will do with an .83 housing for track and a ..63 if its going to be mostly a street car, with at least 3,200 stall and no less than 72pnds injectors, and dont forget a good exhaust with 3 inch or 3.5 inch downpipe.

 

[tta1240]

83lbs injectors and a gtq70 would do the trick.a smaller turbo would also work.