low reverse clutch housing removal

[WE287GN]

is there any way to get this out without the special tool?

and if not can any here supply one ? is soo drop me an email, either that or i could try bringing it to the local tranny shop and have them pop it out, its a shame to get this far and be stuck for one silly tool

thanks
Chris P.

 

[GNeric]

You can reach down in the center with a hook/pick tool and pull it upwards. If you have two tools, one on each side and lift evenly to get it out.

I got my "special tool" from Hayden Trans Tool off of a Matco truck about 12 years ago.

 

[KEhrhardt]

See this thread about GM LO/REV Installer Removal tool:

http://www.turbobuick.com/forums/showthread.php?s=&threadid=18926

HTH

Kurt Ehrhardt

 

[WE287GN]

thanks for the info Kurt,and GNeric it is much appreciated.