I always wanted the GNX gauge cluster, but was always so expensive and the only times I saw one for sale was when I couldn't buy anything. So after modernizing the Buick during it's restore I thought to just make my own but with LED gauges instead. I looked at Dakota Digital but didn't like not seeing any type of bar or needle go up and down and then I saw these from Intellitronix:
The bottom panel on the left has the GPS speedometer circuit showing under the tinted glass. I liked how it had the three LED indicators so I didn't to just hide that away somewhere. The bottom right has an air/fuel ratio gauge and boost gauge. I'll be doing the same tinted glass for the radio and air con. bezel, mounting a tablet over that hole with the air con. controls behind it. The faceplate I tend to make will be hinged and swing out to get to them.
The bottom panel on the left has the GPS speedometer circuit showing under the tinted glass. I liked how it had the three LED indicators so I didn't to just hide that away somewhere. The bottom right has an air/fuel ratio gauge and boost gauge. I'll be doing the same tinted glass for the radio and air con. bezel, mounting a tablet over that hole with the air con. controls behind it. The faceplate I tend to make will be hinged and swing out to get to them.
