89mulletbird
Member
- Joined
- Jun 24, 2004
- Messages
- 363
I have an 200r4 Art Carr manual (engage by shifting into "1") transbrake. I'm pretty sure it is the "Stageright transbrake". I just had my trans rebuilt and now the transbrake is
1) hard to engage, I have to rev the engine in LOW to engage
2) It slips under partial throttle, car creeps forward
The instructions here are a bit skimpy.
https://stagerighttransmissions.com/assets/pdf/srtTransbrakeInstructions.pdf
I don't understand the part 3 about remove the overrun valve and re-install with the check ball first. Are you just taking the check ball from the valve body and installing it here instead? I need to know what I am talking about when I call the transmission builder to discuss fixing this...
1) hard to engage, I have to rev the engine in LOW to engage
2) It slips under partial throttle, car creeps forward
The instructions here are a bit skimpy.
https://stagerighttransmissions.com/assets/pdf/srtTransbrakeInstructions.pdf
I don't understand the part 3 about remove the overrun valve and re-install with the check ball first. Are you just taking the check ball from the valve body and installing it here instead? I need to know what I am talking about when I call the transmission builder to discuss fixing this...
Last edited:
