Drewster
Wish I Had A Clone. AKA Andrew Youlio
- Joined
- May 31, 2001
- Messages
- 787
Im trying to figure out if my line bore was done too deep into the block.
the distance from the cam center to the crank center is 4.3005". Which i believe means the distance is .030 under.
There is the posiblity that the cam bore was not made where it should be.
I was wondering how to verify the depth of the crank line bore and what to use for reference.
Andrew
the distance from the cam center to the crank center is 4.3005". Which i believe means the distance is .030 under.
There is the posiblity that the cam bore was not made where it should be.
I was wondering how to verify the depth of the crank line bore and what to use for reference.
Andrew
