NEED DESPERATELY!!! atr header clamp

[DCVING 6]

Seems the coating placed tossed one of the clamps for my ATR headers . Does anyone have one laying around on a shelf somewhere, or know of a similar piece that would fit?

 

[grocerygetter]

I need a clamp and a gasket...I bought a kit from ATR...I'm watching to see what they tell you!

 

[petesgn]

Here check this out

http://cgi.ebay.com/ebaymotors/2-V-...33634QQitemZ8045667208QQrdZ1QQsspagenameZWDVW

 

[grocerygetter]

is that the right size? The internal diameter of my crossover at that point is 2.5".

 

[petesgn]

is that the right size? The internal diameter of my crossover at that point is 2.5".

Sorry about that
http://cgi.ebay.com/ebaymotors/2-5-...ryZ33634QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

 

[grocerygetter]

thank you! I wasn't sure if you ordered them by internal diameter or not...I'm buying one now.

 

[petesgn]

I just measured my atr crossover and the size is 2 1/4

http://cgi.ebay.com/ebaymotors/2-25...ryZ33634QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

 

[Brer Rabbit]

Try this place guys.

www.spdexhaust.com they have everything there.

 

[Louie L.]

I tried a 2.5 on my ATRs and it was too big.The clamp tightened up all the way until both ends toughed each other. The connection seemed fairly tight but the fact that both
ends of the clamp were easily touching led me to believe that it wasnt as tight as it shouldIt could work with 2 fresh thicker gaskets and lots of copper RVT.

 

[channer]

grocerygetter - did you get your clamps

Hi grocerygetter...

I was wondering if you got your clamps for your ATR headers? Did you get the 2.25" and did it fit?

thanks.... dave

 

[grocerygetter]

2.25" is what fit...I got a 2.5 free so I tried it...also got a 2" free so I tried it also...2.25" is what you need bro.