Need some help reading my powerlogger runs

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

BARRACUDA1968

Well-Known Member
Joined
May 4, 2011
Messages
1,270
I made a couple pulls yesterday using the powerlogger. The first run was a 3rd gear pull and the second was a roll on from 15 mph through the gears. I got cut off at 87 mph on this run for some reason.

Would like some insight. I had some weird knock, probably from being too rich but take a look. I just re torqued my knock sensor to 14 ft pounds and now when I get knock it's crazy high.

My chip is a TT 93 with alky timing is 23/21 I had 1 degree of timing out in 1st and 3 degrees in the other gears. Fuel is chip setting. Alky on 6.

Boost is 22
 

Attachments

Here is a couple shots of the data for those that don't have the PL software.

It's a little crude but I don't know how to post the image so I just took a picture.

My 02 readings say I'm not overly rich but my AFR is buried in the 7's most of the pull.


 
Well, the most obvious thing I see in those pictures is that you have something set up wrong on your F3 data page in regards to what wideband O2 you're running.
 
Back
Top