New Downpipe 3" SS

[Nick Micale]

This pipe was used as a pre-production unit to check fitment. It was not run, and the car was not even started with this pipe installed.

The last section of the pipe was cut and welded for exact alignment on a stock GN so the production fixture could be finalized.

The flange and puck assembly is all stainless, made by RJC.

Price is $350 plus shipping, and a test or dump pipe can be furnished as extra cost.

 

[Nick Micale]

Here is a picture:

 

[Tom Walker]

I'm interested. How much shipping to 46237 and will you take a money order?

 

[Nick Micale]

Shipping and insurance is $20 to you, and a MO is fine.

 

[Tom Walker]

I'll take it!

If you'll send me a payment location and how you want MO made out, I'll get it in the mail tomo... Tom

 

[nonoss38]

If he does not buy it ,,,I will..

Thanks

 

[Tom Walker]

Believe me, I'm gonna take it. Just waiting on instructions. This is a great deal!

 

[Nick Micale]

Thanks Tom, you are correct, it IS a great deal, and it will be on the way to you!

 

[Tom Walker]

Thanks, Nick. A pleasure doing business with you...

 

[Tom Walker]

Payment

Good Morning, Nick! "The (cashiers)check's in the mail'! Thanks again...Tom

 

[Tom Walker]

Got It!

This a beautiful piece. Noticed the puck swings about 50* or 1.3" before it hits the side wall of the housing. Don't know how far it should swing. Is this ok?

 

[DCVING 6]

This a beautiful piece. Noticed the puck swings about 50* or 1.3" before it hits the side wall of the housing. Don't know how far it should swing. Is this ok?

Not sure if you read in the Lounge, but Nick is recovering from a heart attack that happened on Sunday so he probably won't be responding to this ASAP. I would put a post in the general tech section.

 

[Tom Walker]

Nick

No, I don't make it to the lounge. So sorry about the heart attack. Hope his recovery is swift and permanent. Thanks for the update...