OEM front upper and lower control arms

[brandnu6]

Hello all. I installed a set of "tubular upper and lower " front control arms with "polyurethane" bushings! would like to go back to "original "set up" with "rubber" bushings. Does anyone have a set they no longer need. Unfortunately, I tossed mine out. My bad! thanks very much.

 

[MNPete]

Jack's in Billerica (1-888-873-5225) has all for in a 1986 Regal they are parting. 35ea for uppers/ 49ea for lowers.

I like to find parts in junk yards. Hope it helps.

Have a nice day.

-Pete

 

[Turbo6inKY]

If you want new:

https://www.speedwaymotors.com/Dorman-Products-520-137-Upper-Control-Arm-LH-1982-2005-GM,292458.html

 

[brandnu6]

Jack's in Billerica (1-888-873-5225) has all for in a 1986 Regal they are parting. 35ea for uppers/ 49ea for lowers.

I like to find parts in junk yards. Hope it helps.

Have a nice day.

-Pete

Thanks Pete. Take care.

 

[Chuck Leeper]

Just a "FWIW" comment.
The new arms likely have poorly made ball joints.
We run into this with the "stock replacement" units for the tri 5 Chevies.
We replace them prior to even putting the arms on.
Genuine MOOG.

 

[Blacky]

I believe I have a set of uppers and lowers. I don't think they were rebuilt. They were stock taken off of 50,000 mile GN

 

[brandnu6]

I believe I have a set of uppers and lowers. I don't think they were rebuilt. They were stock taken off of 50,000 mile GN

Hi Blacky. Thanks for your reply. I don't know if it will be worth your time and effort to ship to Massachusetts, after you factor in the cost. I think I'll try to find them locally. Thanks anyway...

 

[Blacky]

I just shipped out a turbo too California and it was quite heavy and it was only 30 bucks to ship. I was very surprised. I think it went to a business that's why because it's cheaper than residential