Pitbull exhaust tips.

[EVIL]

I have a Pitbull stainless exhaust system, so i was told, and it’s missing the tips that stick out behind the tire.

The exhaust tail pipes come from the muffler, go over the rear end, cure down and as soon as they straighten out again they stop right there.

It appears I need a roughly 2 foot piece for each side.

Is this normal for this system?

Where can I fine the proper pieces or will i have to have them custom made?

D

 

[aminga]

Somebody cut them off. The section from the mufflers back is one piece (albeit welded)

 

[pacecarta]

3"or 2.5"

pipe is pipe you could just add to what you have using straight pipe and a band clamp(or weld ) and just cut the exit end at a slant

 

[EVIL]

Somebody cut them off. The section from the mufflers back is one piece (albeit welded)

Thats what i thought.

custom piece it is.

3"or 2.5"

pipe is pipe you could just add to what you have using straight pipe and a band clamp(or weld ) and just cut the exit end at a slant

It's 2.5"

That's what I was thinking of doing.
Have some stainless tips made then cut the slant accordingly.

Thank you
D