Ported M&A heads complete

[Cme2fly]

I'm selling a set of ported M&A heads. The heads were recently checked by Champion Racing Heads and have a clean bill of health. The reason that I'm selling is I decided to go in a different direction with my car. I have owned these heads for over 6 years and they have been great performers. Disclaimer: These heads originally had valve spacing for a 4" bore. They will work on a 3.8" bore but, will require a minor bore notch on the intake side of the bore. The heads have been repaired due to dropping a valve on the number 4 cylinder. The heads were professionally checked and repaired by Champion Racing Heads.

M&A cylinder heads:
PAC-1255 Beehives install @ 1.850..200lbs will accommodate approximately .630 lift
PAC-R313 Chrome Moly retainers
Ferrea 1.9 intake and 1.6 exhaust
Crane 1.6 rockers
Crane guide plates, studs, and adjusters
One piece 9.050, 5/16 .120 wall push rods
Powder coated M&A valve covers with hardware

$1750 OBO.

 

[Cme2fly]

These heads are ready to go. I will include ARP Head studs with the sale of the heads. The PAC beehives are setup for a hydraulic roller. All you need is gaskets and your set.

 

[Cme2fly]

Heads, rockers, and hardware.

 

[Cme2fly]

Ported irons are $1400. Add a set of T&D rockers, your at $2000. These heads will out perform any ported iron.

 

[Cme2fly]

$1650

 

[Nick Micale]

I would like to talk to you about these heads.

Send me your number, or call me at 602-866-9908, thanks.

 

[turboc87gn]

So these would be at home on a 4.1?

 

[Nick Micale]

Greg, I will call you tomorrow and finalize the sale and payment for your head package.

 

[turboc87gn]

I wasnt trying to buy them i have a set of ported irons im using i was just curious trying to learn

 

[Cme2fly]

Sold!

 

[Cme2fly]

So these would be at home on a 4.1?

Yes, they were at home on a 3.8 too. The heads originally had 2.02 intake valves.