Powerlogger blm cell highlight

[Roc87]

Updated the powerlogger with the newest drivers and key on/engine off I can click in the blm cells and a window pops up to enter the new number, I enter the new number and the cell shows the change for a second then reverts back to what it was. Any ideas what's going on?

 

[TurboDave]

What mode were you in? Review or Monitor?

 

[Roc87]

Monitor I believe

 

[Eric Stage I]

I would check again that you have the latest Powerlogger software. PLC version 2.5.2.

Also, make sure you reflashed the Powerlogger board with the newest PL044 file.

 

[Roc87]

Oops, I didn't reflash the board.

BTW, just shipped a chip to you this morning, will be ordering a e85 6.1 from you tomorrow or Thursday.

 

[stevek]

you can change it with the fuel peddle and scan master if you have one