Pump ALWAYS running

[MikeV]

I just finished installation of my Razor's alky kit, and turned the key to the ON position to run the tests in the installation guide. The pump is running. Constantly. I can turn the little knob and hear it speeding up, and it will shut off if I turn the little knob to the OFF position. Any idea where to look? I'm losing daylight...

 

[Razor]

3 bar MAP sensor... unplug the 3 bar and see if the kit works normally.. if so.. then its a 3 bar MAP wiring issue.

All else.. call me tommorrow

 

[MikeV]

Ug, didn't change anything. One last question, then I'll call you tomorrow afternoon. For the ground wire on the pump, I attached it to the pump bracket screw on the back of the pump. The bracket is aluminum. Will that work? The O-ring connected to the wire was too small to fit around the bumper bolt. :frown:

 

[Razor]

Ug, didn't change anything. One last question, then I'll call you tomorrow afternoon. For the ground wire on the pump, I attached it to the pump bracket screw on the back of the pump. The bracket is aluminum. Will that work? The O-ring connected to the wire was too small to fit around the bumper bolt. :frown:

Thats fine.. call me tommorrow..

 

[MikeV]

You were right, I had tapped the green wire into the wrong place under the dash. I undid it and ran the green wire out to the MAP sensor and now it works like a charm. Now if only I can make this wastegate go higher than 17 psi...

Thanks!!