Rear end girdle ?

[bttwracing86T]

How hard is it to install and with a mid 10 sec car with Moser axle c clip eliminators. Do I need all is stock other than that

Posted from the TurboBuick.Com mobile app

 

[pacecarta]

its not hard,just replaces the stock cover
once its on and torqued then tighten the cap support bolts as recommended in instructions and lock them down

 

[Superrmario]

Super easy install..

Just tighten the cap bolts to the right TQ as Pacecarta said and your good to go.

 

[pacecarta]

i wouldnt say good to go
the rear should be upgraded axles and carrier for the power level as well as the driveshaft

i ran a lot of mid10s and 1.4s no girdle but on 33s and a spool , didnt put on the girdle until it was almost at 135 mph

 

[bttwracing86T]

Sweet

Sent from my XT907 using TurboBuick Mobile mobile app

 

[Superrmario]

i wouldnt say good to go
the rear should be upgraded axles and carrier for the power level as well as the driveshaft

i ran a lot of mid10s and 1.4s no girdle but on 33s and a spool , didnt put on the girdle until it was almost at 135 mph

Not at all..

I was just commenting on the actual install...

Sent from my SCH-I545 using Tapatalk

 

[Undercover87T]

I have the TA girdle. Easy install, adds some fluid capacity as well. I have a crossflow exhaust but there is enough clearance to access everything.