?'s....something for everyone to answer

[buickbert]

ok here we go,

what year s-10 wheels cylinders for the rear?

please name all the sensors for the engine (putting in a new motor and want to replace some of them just to make sure everything is on the up and up)

is there a difference in the door panels from a gn with power windows to one with crank windows?

i bent up my tranny lines pulling my motor out, will ones from a 87 cutlass with 307? and 200r4 work?

if i think of more, ill add on th this post.

any info helps

buickbert

 

[buickbert]

info on car

whoops! i knew that i forgot something. its a 87 gn, the motor was just finished being rebuilt, its going to be put back into the car in 2-3 weeks.
.030 over forged pistons, .010/.010 on the crank, full arp hardware, poston cam, port and polished heads with comp cam springs locks and retainers, bigger valves with 3 angle valve job, minor port work on intake, accufab adjfpr, 38#injectors (for now),ram chargers dual fans with caspers wiring, ta-49 with aluminum inlet, kirbans maf tube, thdp, hi flow cat, 3" torq tech single shot with flowmaster muffler, art carr rebuilt trans ( was done prior to me purchasing the car, dont know too much about it, pretty sure its a 3200 stalll conv in there), 1st owner put 4.10's in the rear ( i plan on installing the 3.42 again, they are in a box at my house), umi tubular lower contral arms, going to be ordering a higher flowing fuel pump( i keep seeing 255gph pumps on ebay, is that enough? are they any good? fullthrottle sells them i think0, after the motor is in and broken in, at some point i am going to add alky and a bigger intercooler, but my bank account isnt liking me right now.

hope thats enough info

buickbert

 

[buickbert]

anyhting helps guys

buickbert

 

[QUIP'6']

its part # w37644 at advanced auto its off of an 1984 chevy s-10 blazer 7/8 bore. all the sensors can be located on the turbo regal website under sensors

 

[Quick6'n'-K.C.]

89 s-10 4 cyl 5 speed is the correct rear wheel cyl's

Engine sensors avail at auto store
02 sensor
tps should be fine, check it with your scantool
coolant temp top
coolant temp middle
coolant temp left
air inlet temp at maf
crank sensor


I would purchase a cam sensor from www.rockauto.com 40.00 -50.00!!!!!
I can give you the part number if you want, i ordered 5 and they came from cap to cam sensor gear/shaft all one entire unit.

You can use the power window uppers on the crank window car, but you might have a small opening behind the crank handle, if you are buying a used set, then buy the correct ones.

You might be able to use the lines, depends on where they stop near the radiator, need to compare the 2.

Dont buy the ebay fuel pump, buy it from www.fullthrottlespeed.com , you know you will get a good pump if you buy it from him.
BW

 

[QUIP'6']

89 s-10 4 cyl 5 speed is the correct rear wheel cyl's

Engine sensors avail at auto store
02 sensor
tps should be fine, check it with your scantool
coolant temp top
coolant temp middle
coolant temp left
air inlet temp at maf
crank sensor


I would purchase a cam sensor from www.rockauto.com 40.00 -50.00!!!!!
I can give you the part number if you want, i ordered 5 and they came from cap to cam sensor gear/shaft all one entire unit.

You can use the power window uppers on the crank window car, but you might have a small opening behind the crank handle, if you are buying a used set, then buy the correct ones.

You might be able to use the lines, depends on where they stop near the radiator, need to compare the 2.

Dont buy the ebay fuel pump, buy it from www.fullthrottlespeed.com , you know you will get a good pump if you buy it from him.
BW

sorry buddy but your wrong on that year they are 3/4 inch bore

 

[QUIP'6']

89 s-10 4 cyl 5 speed is the correct rear wheel cyl's

Engine sensors avail at auto store
02 sensor
tps should be fine, check it with your scantool
coolant temp top
coolant temp middle
coolant temp left
air inlet temp at maf
crank sensor


I would purchase a cam sensor from www.rockauto.com 40.00 -50.00!!!!!
I can give you the part number if you want, i ordered 5 and they came from cap to cam sensor gear/shaft all one entire unit.

You can use the power window uppers on the crank window car, but you might have a small opening behind the crank handle, if you are buying a used set, then buy the correct ones.

You might be able to use the lines, depends on where they stop near the radiator, need to compare the 2.

Dont buy the ebay fuel pump, buy it from www.fullthrottlespeed.com , you know you will get a good pump if you buy it from him.
BW

this is the one

 

[Quick6'n'-K.C.]

this is the one

You sure thats it cause i dont see anything :biggrin:

You want me to do a search? where did you get your info?

Those are the ones on my car

Later buddy.
BW

 

[buickbert]

the ebay fuel pumps on ebay, some of them are from fullthrottle
would it be better to just order one from them? same price?

so which wheel cylinders are they? im
buickbert

 

[turbobose13]

what ever the year of the s10, the part number is w37644 for the wheel cylinders.

 

[BLACK MAGIC RACING]

Ive cross-referenced mine, they're from an 84 s-10 or s-15 with MANUAL TRANSMISSION, the most important factor.