Stage II dry sump covers

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

CTX-SLPR

Active Member
Joined
Feb 4, 2004
Messages
1,935
Howdy,

how many different designs of Stage II dry sump front covers are there? The one I got looks quite a bit different from the one that you see pictured most places. Its thicker and isn't as wide so it leaves the oil pickup gallery half uncovered. Also when I mocked it up with my Rollmaster double roller and put the stage 2 hub on the rings bottom out on the cover before I get it all the way on to the crank. Granted I didn't have the oil slinger on there but it shouldn't make that much of a difference. Finally I think this cover has been machined for a billet roller cam, can someone tell me from the below picture?
 

Attachments

  • Stage II front cover inside.JPG
    Stage II front cover inside.JPG
    71.1 KB · Views: 143
It may br for an off-center block. It would be .125 thicker. Whats the Part #? Does it have a "C" after It? I have one that has a "C" on it, and is thicker then the other ones i have.
 
Most of the part number has been milled off so all that is left vissible is a 9. I bought it from Mike Booher as a used piece off or either one of his part motors or his blown stage II rail motor. I'm pretty use its for an off center, this is going on a production block by the way as the upper section of my custom gerotor oilpump front cover. See the attached picture
 

Attachments

  • Stage II front cover outside.JPG
    Stage II front cover outside.JPG
    80.5 KB · Views: 131
Back
Top