Stock dash for swap

Vandal1987

Member
Joined
Aug 12, 2012
Would anyone know what I need to do to just run the dash lights fuel level and headlights and signal lights etc by them selves. I will be doing a ls swap and was hoping to retain stock stuff
 
Not sure what you're asking, most LS swaps are wired for "stand alone". The pcm is just controlling the engine and maybe the trans (some need separate TCM, trans control module) but most of the time, all other electrical systems are left stock
 
Not sure what you're asking, most LS swaps are wired for "stand alone". The pcm is just controlling the engine and maybe the trans (some need separate TCM, trans control module) but most of the time, all other electrical systems are left stock

Eric, you got that rag running on the street, yet?:D
 
Eric, you got that rag running on the street, yet?:D

Its getting all prettied up, at the painters. Shouldve done more tuning on it before pulling all the parts off for paint since it got to the painters about 2 months after it was supposed to.
 

Attachments

  • 20190520_152537.jpg
    20190520_152537.jpg
    5.7 MB · Views: 54
I have done a few LS swaps and the dash still functions as normal, you will just need the proper adapters for your sending units.
 
Top