Street/strip 2004R w/brake

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

brian

Senior Member
Joined
Jul 4, 2001
Messages
1,203
Street/Strip 2004R lock up. Ready to ship out.
This is a Monte SS CZ hi-po valvebody (model), and the trans has all my usual parts. 550 and 400 boost valves, pump ring kit, Alto clutches (extra throughout) and wide Red band with our shift calibration.(shift kit)
This unit is a lock up with a modded 694 servo. The input shaft and drum are hardened. Has a stock pan with a custom baffle for fluid control, and a drain plug installed.
This trans will have nice firm shifts, and shift at nearly 5500 at WOT. Perfect for a ported heads and cam car.
Biggest difference between this and the BRF is a later WOT upshift, 5200`ish vs 5500, and a slightly earlier third gear while cruising. (most people never notice) With all correct wiring and switches for a GN, with the correct black plug.
Price on this unit is $1850 shipped in the U.S. (continental 48) No core needed in return.

For $300 more, we can install a deep sheetmetal pan and bottom pick up for a bit more added insurance.

This transmission should be run with a 10 inch or similar hi-po converter. (9/11,9.5 (non Vig), etc) We could easily change this over to non lock up if desired.
You can also search the trans forum for info on the CZ valvebodies.
This build, when used with the correcct converter is easily capable of running well into the 10`s.

You can view feedback in that forum on this board.
Search under brian, or Brian Hofer
Thank you, Brian
hipsibri@cs.com
 
I'll definately shoot you a PM when I'm ready for my trans. Most likely a couple months from now but TTT for you.:wink:
 
I would trade you outright with a t 350 trans good for the tens built by level10 trans with a 3000 stall converter-package has less than 500 street miles no racing-i paid $1600.
 
Hey Brian, I'm looking forward to putting a few miles on the tranny you built me at the end of last year. Looking for some low 11's at least for sure! Thanks again. Ken F.
 
I would trade you outright with a t 350 trans good for the tens built by level10 trans with a 3000 stall converter-package has less than 500 street miles no racing-i paid $1600.

No thank you.
I would trade for a 100% complete rebuildable motor, all brackets and other pieces.

Thanks, Brian
 
rollerized trans

hey brian is that rollarized trans that you advertised a while back still available.
 
wiring and switches

brian little confused about wiring and switches. i have an 87 with the brf trans. do i have to do any special than just throw the trans in.thanks. please pm me for payment.
 
brian little confused about wiring and switches. i have an 87 with the brf trans. do i have to do any special than just throw the trans in.thanks. please pm me for payment.

PM sent....

It is set up for a GN.
Bolt `er up, plug `er in and go.:)

Brian
 
trans

hi brian, not sure if my PMs got to you. i want the trans and just need an address to send the payment. i will be running a single disc 10 inch 3,000 stall converter . car will go to the track just to seewhat i can run, otherwise i will be driving it on the street as much as possible. thank you.
 
hi brian, not sure if my PMs got to you. i want the trans and just need an address to send the payment. i will be running a single disc 10 inch 3,000 stall converter . car will go to the track just to seewhat i can run, otherwise i will be driving it on the street as much as possible. thank you.


PM sent back at you!:wink:

Brian
 
This trans has sold.

The brake used in this is our own.
Works like a stage right, but is different design.
 
Back
Top