Ta Perfermance Headers Fitment

[ALVAROG1983]

having a bit of a problem maybe someone can have input. I have ta perfermance headers pass side is rubbing up against a-arm and brake lines that run across the motor mount cross member has anyone else experienced this before with these headers. Want to add im running HR poly mounts.

 

[QUIP'6']

having a bit of a problem maybe someone can have input. I have ta perfermance headers pass side is rubbing up against a-arm and brake lines that run across the motor mount cross member has anyone else experienced this before with these headers. Want to add im running HR poly mounts.

yes i had that same problem on a friends car we had to move the brake lines up or down cant remember. call ta performance

 

[turbo nasty]

http://www.turbobuick.com/forums/ge...118-ta-header-fitment-install-experience.html

If you remove the line bracket and bend the lines a lil then put the braket backin 180 from the original it will hold them clear.
Mine did not hit the a arms though

 

[Kent Buckles]

Problem here too. Crossover would not meet with header collectors. Had to cut off 1/2 - 3/4" of crossover to make it fit. V band clamp would not fit then, was way too close to starter and concern over starter possibly getting hot and/or shorting. Put a mini starter on and all is ok now. I too would call TA. I am sure they will work with you.

 

[ALVAROG1983]

or maybe my dumb a22 put the motors mount on the wrong side but from i remember i made sure i pay close attn. to that im going to double check myself.

 

[ALVAROG1983]

Problem here too. Crossover would not meet with header collectors. Had to cut off 1/2 - 3/4" of crossover to make it fit. V band clamp would not fit then, was way too close to starter and concern over starter possibly getting hot and/or shorting. Put a mini starter on and all is ok now. I too would call TA. I am sure they will work with you.

passenger side has been a pain in the a22 even with my dp and not been able to fit a 4inch maf pipe dam worst then my wife. ill try to take pic of this its fu%ken tight spot.

 

[ALVAROG1983]

the reason i want to take care of this is because this can cause false knock or wear a dum hole in the header.

 

[ALVAROG1983]

Problem here too. Crossover would not meet with header collectors. Had to cut off 1/2 - 3/4" of crossover to make it fit. V band clamp would not fit then, was way too close to starter and concern over starter possibly getting hot and/or shorting. Put a mini starter on and all is ok now. I too would call TA. I am sure they will work with you.

crossover looks to be fine but u can really have a battle with those v band clamps.