TCI 200r4

[cwmccray]

I am think about buying a TCI 200r4 tranny. Any feed back on TCI trannies. If this goes well I would end of getting a TCI Turbo 400 for my other car. Shipping from Memphis to Birmingham will not eat me up on shipping. Hell, I might even drive to pick it up.

Chuck

 

[broke1]

Why not just have Brian Prince rebuild your tranny??Hes in Tuscaloosa.Hes built trans for 1ARUNEM,STP,me,and a few others on this board.And hes local too.I beleive he uses the TCI kit too,I know he uses the TCI shift kits.Hell build you a NICE trans for under $1k.

 

[cwmccray]

Hey Broke1
We have been playing phone tag.. I am going out of town to see the "IN LAWs" We are going to have to get together.

Chuck

 

[broke1]

Just gimme a call when you get back in town and I can give ya Brians #.After talking to him you can tell that he is very knowledgeable about 200r4's

 

[cwmccray]

Broke 1
Email your number again
cwmccray@bellsouth.net

Thanks
Chuck

 

[wayner]

I purchased and installed a TCI Streetfighter 200 4R this past spring. I had to fine tune the vaccuum switch for the torque lock/unlock, once that was done it worked flawlessly. It did shift what I thought was a late, for my 3-4 part throttle shift took place at 51 mph, but I just blamed that on my 3.31 rear gears and left things alone. My WOT tranny shifts are at 5100 RPM. It shifts nice and firm, but not neck snapping. This tranny is sitting behind my 461BBC in my camaro and I have put quite a bit of miles on it so far. I don't race at the track and only run street tires.